Enter the area and paver size to get the paver count, the base and sand volumes and the edge length.
Each paver covers its own length and width plus one joint gap on each direction, so the number of pavers for an area is the area divided by (paver length + joint) × (paver width + joint). The tool rounds up, then adds your extra allowance for cut edges and breakage and rounds up again, because pavers are sold whole.
Paver patios are laid on a compacted gravel base with a thin layer of bedding sand on top. The base volume is area × base depth. Gravel compacts when it is tamped, so the tool adds an assumed 20% to the loose volume you order. The sand volume is area × sand depth with no allowance. The weights use typical densities of about 1.4 short tons per cubic yard for crushed gravel; your supplier's number takes priority.
Example: a 12 × 10 ft patio is 120 sq ft. With 12 × 12 in pavers and a 1/8 in joint, each paver takes about 1.03 sq ft, so about 118 pavers are needed. With 10% extra, buy 130. A 4 in gravel base is 120 × 4/12 = 40 cu ft, or about 1.8 cu yd once the compaction allowance is added.
The edge restraint figure is the perimeter of a rectangle. Curved shapes, steps, drainage slope and local frost rules can change the design, so use this as a planning estimate and confirm the details with your supplier or a local installer.
How many pavers do I need per square foot?
A 12 × 12 in paver covers about 1 sq ft, so you need about one per square foot. A 4 × 8 in brick paver covers about 0.22 sq ft, so about 4.5 per square foot. The calculator also accounts for the joint gap.
How much extra should I order?
About 10% is common for straight patterns. Diagonal, herringbone and curved layouts waste more, so 15% is a safer choice. Keeping a few spares is also handy for future repairs.
How deep should the gravel base be?
Many patios and walkways use about 4 to 6 inches (10 to 15 cm) of compacted gravel, and driveways use more. Local soil and frost conditions matter, so follow the paver maker's instructions or local guidance.
How much bedding sand do I need?
A layer about 1 inch (2.5 cm) deep is typical. The calculator shows the volume. Jointing sand to fill the gaps afterwards is bought separately.
What is edge restraint?
It is a border, often plastic or metal, staked in place around the outside of the pavers so they do not creep sideways. The tool gives the perimeter of a rectangle as the length to buy.